John Reid Towel Ring September 22nd, 2018 - 02:44:45
Once I put the tape on the wall, I'm going to remark my measurements and then I'll know exactly where I'm supposed to be drilling.. The next thing to do is to drill some holes. I got a masonry bit here that I'm going to go through the tiles with. It'll go right through the tiles so that you can get your wall pugs into the wall.. Okay, I've drilled, my holes and now I'm going to put a wall plug in the hole.
If your wall plug is a little tight tap it in with a hammer. We need to pull these plates out of your towel rail and then we'll screw them to the wall. When you take the plates out of your towel rail, you need to use the Allen key that was provided in the packet. Okay. I screwed my plates onto the wall. I'll check a measurement from the bottom of the tile up to this.
Just to make sure that they're level. Now I'm going to put my towel rail on and then I'll tighten it up using the Allen. Key. Then we'll just check it with the level to make sure it's right. Okay, now my towel, rail is up.
It's nice and level. Follow the same process for any other accessories that you are going to attach to tiles. And that's how you install bathroom accessories into tiles.