Christian Norton Towel Ring September 22nd, 2018 - 02:52:47
Then I'm ready to mount the wall bracket on the right with another screw. This one is going directly into the stud on both brackets keep them loose for now. They be tightened later now I'll check to see that my towel bars is correctly on the bracket and I'll look to see that it's level. It's definitely looking good. So I'll finish mounting the brackets on the wall.
Here, I'm using a pencil to mark the position of the bottom hole in the bracket because the brackets are loose. I can get behind them easily to drill the final holes on the left side. I'M drilling a hole big enough for the wall anchor like before I'll fold. This anchor first and insert it into the hole. The right side doesn't need an anchor so I'll, just drill a hole right here.
At this time I can screw in the last fuse and tighten the brackets to the wall in the permanent positions. Don'T forget to tighten the top screw as well. I'M just about ready to put the towel bar on the wall. Take the set screws and screw them into the bottom of the towel bar on the left and right sides with the included Allen. Wrench don't twist them in too far, though the bar can be hung on the wall brackets, and the last thing I need to do is tighten the set screws.
This is probably the most difficult part of the installation, because the screw is so close to the wall. It will take quite a few twists, but you'll know when is tight when both set screws are tight, the towel bar should be solidly attached to the wall for the second towel bar I'll. Just repeat the same steps to get that one mounted. This really isn't a difficult installation and can probably be done in about 30 minutes. If you can do this, you'll be able to hang towel rings.